Short Course on – Covering The Basics
Tips for Installing the Spin-On Fuel Water filter
When it comes time to install the spin on fuel water filter, there are certain essential things that you should remember. First, you should make sure that you have inspected the older filter. You should look to see whether it has any kinds of leakages or damages on it. If there is an issue that you identify, make sure that you have noted it down. The next step involves the removal of the filter. It is recommended that you have cleaned any contaminants before the replacement of the filter.
Before you begin the replacement of the spin on the fuel water filter, it is vital to make sure that you have to take safety precautions. First, ensure that the engine is off and the place around the filter is cool. Fuel is flammable, and you do not want the chances of a fire happening. To be on the safer side, ensure that you have a fire extinguisher in case a fire occurs.
It is always recommended that you put a small container below the filter. It is going to collect all the dirt and contaminates instead of them leaking to the ground. It is always vital to make sure that you have closed the valves that lead to the filter. The aim is to prevent the fuel from leaking out. To drain the filter, you should open the drain plug (rotate the plug to the left until it is entirely open. To remove everything from the bowel, you should spin it.
Clean the filter using a clean rage. Wipe it thoroughly to make sure that it looks smooth and clean. It should not contain any foreign material. For correct installation, you should make sure that the filter is completely clean. You should clean not only the filter bowl but also the place that is surrounding.
Ensure that you lubricate the filter gaskets before you do the installation. You should use your fingers to apply the lubricating oil on the entire filter bowl entirely. This will ensure that it will run smoothly after the installation. The lubrication of the gasket will ensure that the filter will run smoothly after the installation.
While ensuring that the filtering bowl is inside the touched the base of the contact plate, install the filter. Always ensure that the filtering bowl has touched the plate. To install the filter, you should turn until it fit entirely the gasket. The number of turns depends on the type of engine. Some require a full turn, other three-quarters turn, while some need a one and a half turn. On the installation manual, you will see the instruction on how to install the filter properly.
After mounting, ensure that it is tight. Examine the filter to make sure that it is correctly in place. If you see any abnormalities in the filter, ensure that you call the dealer for any assistance. You should test the filter. If appropriate, you should tighten the filter to prevent any leakage of the fuel. Put the engine and continue to inspect the filter.